Caution: Do not try to remove a lens if the lens-well appears dry following the disinfecting cycle. Refill the well with fresh saline solution; re-cap tightly and wait 30 to 40 minutes for the lens to rehydrate. If either lens-well repeatedly dries out or leaks, the case should be replaced. Lens cases can be a significant source of microbial contamination. To prevent eye infections, lens cases should be cleaned, rinsed, and air dried every day. Using your multi-purpose solution beyond the discard date could result in contamination of the solution and could lead to severe infection, vision loss or blindness. Use of this lens case with heat may cause warpage. Use for storage during chemical disinfection only. Do not use with heat. If eye infection, pain or irritation persists with lens wear, remove lenses promptly and contact your eye care practitioner immediately. Never reuse, or top off old solution left in your case as solution reuse reduces effective lens disinfection and could lead to severe infection, vision loss, or blindness. Topping off is the addition of fresh solution to solution that has been sitting in your case. Do not store your lenses or rinse your lens case with water or any non-sterile solution. Only use fresh, sterile, solution so you do not contaminate your lenses or lens case. Use of non-sterile solution can lead to severe infection, vision toss or blindness. Never heat lenses in disinfecting solution; not for heat disinfection. Chemical disinfection only! Keep away from small children.